Athearn Marine Agency, Inc. – Marine Brokers for Commercial Fishing Boats and Permits East Coast United States

63' Steel Clammer

Listing # CL5323

Hull TypeSteel
Length (LOA)63 ft.
Breadth22 ft.6 in.
Depth8 ft.4 in.
Draft7 ft.
Year Built2004
Built ByTradewinds Offshore Services Inc.
Gross Tons80
Send Offer or Inquiry


Federal Permits

Federal open access fishery permit


Fuel: 5000 gallons of Diesel


Main Engine: 300HP, (2) Caterpillar 3406 Diesel
Transmission: (2) Twin Disc MG-514
Gear Ratio: 3.5:1
Steering Type: Hydraulic

Auxiliary Engines

Isuzu - 30 KW Generator

Safety Equipment

Elliot 6 person life raft
4 life jackets
30" life ring
6 survival suits
6 fire extinguishers
Segregated 12V PC power supply for emergency communications
First Aid kit
Distress signal kits


Galley on deck
5 berths
Electric stove
Mess table with upholstered benches
TV/DVD player


Radar: Furuno 1835-48 mile
Plotter: Laptop with Nobeltec software
Sounder: Furuno FCV-588
VHF: (x2) Icom M506
AutoPilot: Simrad A20-04
GPS: Sitex SVS-500
VMS (Black Box): Qualcomm
Alarm System: High water/low oil
Furuno loud hailer
Pioneer CD player
Navigation station fitted with bilge high water alarm
The navigation's station filled with oil pressure, water temperature and gear oil pressure alarms for both engines

Deck Equipment

Pullmaster H-18 trawl winch
Steel A-frame
Dredge retrieval for dumping by a Pullmaster PL-5
Steel mast
Galvanized steel stabilizers
2 Pullmaster PL-5 stabilizer winches
6 cylinder Cummins 6C diesel clam pump engine
Weinman 2,000 GPM clam pump
Emergency lighting system
Flomax electric pump and two bilge pumps
Galvanized clam tank set into deck holds 8 clam cages
48" clam dredge
300' 6" clam hose


2018/2019 the following major projects were completed by the owners at a cost in excess of $650,000.00.

  • Replace aft deck plate
  • Build/install a clam tank
  • Re-wire the vessel
  • Install new hydraulics: all new hoses & pumps
  • Install new winches 
  • Re-locate the new diesel pump engine to the engine room
  • Install a new diesel generator set
  • Build, install outriggers and winches 
  • Re-configure the rigging/masts/booms
  • Re-configure the crew accommodation, install new galley
  • Haul, UT bottom plate, insert new plate as necessary 
  • Pull shafts, props, rudders. Replace port shaft, rudder shafts, replace all bushings/bearings 
  • Install new keel coolers
  • Install new electronics 
  • Clean fuel tanks, paint out vessel 100%
  • New watertight doors throughout


$850,000 USD

Send Offer or Inquiry

** The information given is believed to be correct but cannot be guaranteed **